 |
» |
|
|
|
|
|
|
|
|
|
|
|
|
|
Dual Rack Cooling:
- Supports single or Dual Rack cooling
Automatic door opening and MCS fans:
- Ability to enable/disable automatic door opening feature.
- Two new temperature thresholds will cause the doors of the rack to open and the fans to shut down (if equipped with a door opening magnetic locks). A critical alarm and SNMP trap is issued for either event. Magnetic door lock status is shown on the Overview page.
- An overheating event caused by loss of water flow less than 10 l/minute (2.64g/minute). An overheating event at least 5ºC above the loss of water flow temperature threshold.
- The MCS fans will be turned off if a leak is detected by the leak detection sensor (not the condensation sensor).
Two new condensation pump threshold warnings will alert and issues SNMP traps if the pump has run over a specified amount of time or a specified number of pump running cycles.
- Excessive Moisture: Condensation Pump Cycles Warning Threshold.
- Excessive Moisture: Condensation Pump Running Time Warning Threshold.
- The LCD display will show three new messages when conditions exists "Emergency Door, Heat"," Emergency Door, Flow", "Excessive Moisture".
Additional changes:
- The Low Temperature Threshold minimum is changed to form 10ºC to 2ºC and maximum is changed from 40ºC to 30ºC.
- The Server Intake Temperature Set Point maximum temperature range is changed from 70ºC to 30ºC.
- The High Temperature Threshold maximum temperature range is changed from 70ºC to 40ºC.
- The Warning Temperature Threshold maximum temperature range is changed from 70ºC to 40ºC.
- Fan speed target was modified to reflect 4 fan speed levels.
Additional enhancements:
- Displays health of both power supplies on home page.
- Units name or ip address is displayed on top frame of every web page.
- Support for an optional external relay module.
- Product ID and serial number can be set from the serial interface, are displayed on the Identification page and will be available via SNMP for HP SIM and other monitoring applications.
- Daylight Saving Time defaults for US/Canadian laws taking affect in 2007.
- DST Begin changed from 3.5.0 to 3.2.0.
- DST End changed from 10.5.0 to 11.1.0.
|
|
|
|
|
|
- The PID settings were changed to reduce response time of system to external changes and also to achieve steady state within a short time frame.
- Include Target and Current valve opening percentage.
- Modified Graphics on home page to enhance reading.
- Inserted a column in the Setup/Accounts Tab to indicate allowable usernames.
- The MIB was updated to accommodate new parameters under the MCS G2.
- Temperatures logged that are outside the limits of the sensors will show "--ºC" or "--ºF."
|
|
|
|
|
|
- Monitor Status
- Cooling Capacity
- Water Inlet Temperature
- Water Outlet Temperature
- Magnetic Water Valve Open or Closed
- Air Inlet Temperature
- Air Out Temperature
- Fan Speed
- Water System Integrity
- Water Flow
- AC input 1 & 2
- Customizable Cooling System Parameters
- Air Temperature
- Alarms / Warnings
- Cooling Capacity
- Advance Settings
- Timers
- Logs
- Alarm History
- Detail Event Logs
- Able to send SNMP traps to HPSIM
- Warnings
- Magnetic Valve Failure
- No Fan Module Available
- No Water Module Available
- Condensation Warning
- Alarms
- Temperature Alarms
- Fan Alarms
- Water Flow
- Water Leakage
|
|
Printable version
